EMEE Frost Protection Switch EMEE Frost Protection Switch EMEE Frost Protection Switch

Frost Protection Switch
Designed & manufactured by EMEE

The EMEE Frost Protection Switch has been developed specifically for New Zealand conditions. Prevent Low temperatures (Frost) damage to your equipment. Protecting Pumps, Pipes, Tanks and motors all winter long.

OPERATION

This unit is specifically designed to switch (On or Off) a heat lamp or heater up to 2kw or 10 amps at 230 Volts AC 50Hz or 1.3 kW 5 amps at 110 Volts AC 60Hz.

Fixed switching (On) takes place between plus 2 to 3 Deg Centigrade decreasing and turns off on a rising temperature of round plus 5 Deg Centigrade.

The unit will remain in the Off position whilst the temperature remains above 5 Deg C.

The unit’s internal construction is made from proven modern sensitive and approved components applied to a professionally made printed circuit board. Housed in a flame retardant ABS plastic enclosure (material carries a UL flammability rating of 94V-0)

INSTALLATION

Simply connect (plug-in) unit to an AC 3 pin outlet and then “piggy back” the controlled appliance to the outlet side of the connection plug. Turn on the unit and leave. 24/7 Operation. Power saving.

It is advised to place the unit within an area where it will sense the ambient surrounding temperature but not covered.

DO NOT IMMERSE IN ANY LIQUID

The temperature sensing is within the unit enclosure and is governed by the surrounding ambient temperature of where the unit is installed. Do not have the unit placed near the heating device that it is to control.

TESTING

To test the output operation simply press and hold the Red Test Button on the left side of the unit. This will over-ride the internal temperature sensing therefore turning on the Heat Lamp or other controlled devices attached.

When the LED Indicator is bright this shows that the unit has switched the Female part (output) of the 3 pin plug on.

WARRANTY

This unit has a total replacement 3-year warranty against workmanship and internal parts.

The warranty does not cover abuse, immersion in any liquid, overloading or being connected to a power source other than as stated above.

COMPLIANCE

This unit has been tested by a NZ Approved Testing Laboratory. The unit’s components comply for safe use. Specific detail and report is available on request.

North American Specifications

Unit Technical information and North American Specifications (PDF).


EMME History
Electical Engineering in NZ

Echo Mechanical and Electrical Engineering was established in New Zealand in 1975 as a Limited Liability Company for the purposes of servicing the precision speed control of machinery and process control industries. Especially the control of generating plant, power management equipment together with ship engine controls and Bituminous Roading Machinery.

Since then, the company has expanded its market to supply and service the whole of Australasia and the South Pacific Region.

The further development over the past eight years has involved the adaption of computers, to interface to our equipment and the development of specialised software to suit applications. Because of the nature of modern technology, being updated and improved at such a phenomenal rate throughout the world, our company has made a dedicated commitment to keeping up with that technology and adapting our product to correspond with it.

The Company employs skilled staff, along with outside contractors who are resourced when necessary. Our staff and contractors are specialists in the areas of Computer Programming, Electrical Engineering and Mechanical Engineering. Our small team of personnel work together to provide to our customers a product that is of the highest quality and a service that is second to none.

Echo Mechanical and Electrical Engineering's main principals include Woodward Governor Company (Channel Partner), Dynalco Controls, Garmin GPS Products.

Clients include New Zealand Defence Force, Downer EDI Works, Fulton Hogan, Fonterra, ABB, Contact Energy, Mighty River Energy, Discovery Cruises, Department of Island Affairs and other Australasian Corporations, TV and Radio Companies, Transport Operators, Local Government and Government Departments.

EMEE


John Mackenzie

Contact Us

John C Mackenzie (MSAE)
Managing Director


3251 Wreys Bush - Mossburn Road
RD 2 Lumsden
Hamilton Burn
Southland 9792
New Zealand

Telephone: +64 3 2486352
Fax: +64 3 2486352
Mobile Phone Number: +64 27 433 4135
Email Address: jcmack@emee.co.nz